Instructions / Assembly

Inject the adhesive into
the hole, starting from the
bottom, while slowly
drawing back the static
mixer.In any case avoid
entrapping air. For deep
holes extension tubing can
be used.
Insert the anchor with a
rotary motion into the
filled drill hole. Some
adhesive must come out
of the hole.
Important: the anchor
must be placed within the
open time.
During the resin hardening
time the anchor must not
be moved or loaded. Wash
tools immediately with
Sika® Colma Cleaner.
Wash hands and skin
thoroughly with warm
soap water.
CLEANING OF TOOLS
Tools must be cleaned as soon as possible with a clean
rag.
LIMITATIONS
THE NTSB HAS STATED THAT THIS PRODUCT IS
APPROVED FOR SHORT TERM LOADS ONLY AND SHOULD
NOT BE USED IN SUSTAINED TENSILE LOAD ADHESIVE
ANCHORING APPLICATIONS WHERE ADHESIVE FAILURE
COULD RESULT IN A PUBLIC SAFETY RISK. CONSULT A
DESIGN PROFESSIONAL PRIOR TO USE.
*The design professional on the job is ultimately
responsible for the interpretation of the data provided
on the product data sheet.
BASIS OF PRODUCT DATA
Results may differ based upon statistical variations
depending upon mixing methods and equipment,
temperature, application methods, test methods, actual
site conditions and curing conditions.
OTHER RESTRICTIONS
See Legal Disclaimer.
ENVIRONMENTAL, HEALTH AND SAFETY
For further information and advice regarding
transportation, handling, storage and disposal of
chemical products, user should refer to the actual Safety
Data Sheets containing physical, environmental,
toxicological and other safety related data. User must
read the current actual Safety Data Sheets before using
any products. In case of an emergency, call CHEMTREC
at 1-800-424-9300, International 703-527-3887.
Product Data Sheet
Sika AnchorFix® S
June 2018, Version 01.02
020205010010000003
7 /
8