Specification

APPLICATION INSTRUCTIONS
SUBSTRATE QUALITY / PRE-TREATMENT
Surface should be clean, sound, dry, and free from dirt
and loose particles. For best results, use a wire brush to
clean off any loose particles or excess dirt or dust. Area
to be repaired should accept moisture penetration.
MIXING
Stir material thoroughly until a uniform appearance and
consistency is achieved prior to use.
APPLICATION
Use a putty knife or trowel to apply product to surface.
Ensure that enough product is pushed into crack or hole
to provide coverage. Tool as required. Areas greater
than 1/4 in. (6.3 mm) deep will require two or more ap-
plications. For applications greater than 1/4 in. (6.3 mm)
depth, allow the material to dry between applications.
Apply at a minimum thickness of 1/32 in. (0.8 mm). Al-
low repaired area to dry and fully cure for at least 24
hours, depending on temperature, humidity and depth
of repair.
CLEANING OF TOOLS
Clean tools immediately after use with water.
LIMITATIONS
Substrate must be dry prior to application (minimum
48 h)
▪
Check color before using, will not change once cured▪
Protect from freezing▪
Do not apply at temperatures below 40 °F (4 °C)▪
Allow the material to dry between applications▪
Cracks or spalls deeper than 1/4 in. (6.3 mm), will re-
quire two or more applications
▪
Allow to dry before subjected to water▪
Not recommended for areas exposed to vehicular
traffic
▪
Do not apply if rain is in the forecast▪
Do not apply over 1/4 in. in one application▪
BASIS OF PRODUCT DATA
Results may differ based upon statistical variations de-
pending upon mixing methods and equipment, temper-
ature, application methods, test methods, actual site
conditions and curing conditions.
LOCAL RESTRICTIONS
Prior to each use of any Sika product, the user must al-
ways read and follow the warnings and instructions on
the product’s most current Product Data Sheet, product
label and Safety Data Sheet which are available online at
http://usa.sika.com/ or by calling Sika's Technical Ser-
vice Department at 800.933.7452 nothing contained in
any Sika materials relieves the user of the obligation to
read and follow the warnings and instructions for each
Sika product for each Sika product as set forth in the cur-
rent Product Data Sheet, product label and Safety Data
Sheet prior to product use.
ECOLOGY, HEALTH AND SAFETY
Keep container tightly closed. Keep out of reach of chil-
dren. Not for internal consumption. For industrial use
only. For professional use only. For further information
and advice regarding transportation, handling, storage
and disposal of chemical products, users should refer to
the actual Safety Data Sheets containing physical, ecolo-
gical, toxicological and other safety related data. Read
the current actual Safety Data Sheet before using the
product. In case of emergency, call CHEMTREC at 1-800-
424-9300, International 703-527-3887.
LEGAL NOTES
Prior to each use of any Sika product, the user must al-
ways read and follow the warnings and instructions on
the product’s most current Product Data Sheet, product
label and Safety Data Sheet which are available online at
http://usa.sika.com/ or by calling Sika’s Technical Ser-
vice Department at 800-933-7452. Nothing contained in
any Sika materials relieves the user of the obligation to
read and follow the warnings and instruction for each
Sika product as set forth in the current Product Data
Sheet, product label and Safety Data Sheet prior to
product use. SIKA warrants this product for one year
from date of installation to be free from manufacturing
defects and to meet the technical properties on the cur-
rent Product Data Sheet if used as directed within shelf
life. User determines suitability of product for intended
use and assumes all risks. Buyer’s sole remedy shall be
limited to the purchase price or replacement of product
exclusive of labor or cost of labor. No other warranties
express or implied shall apply including any warranty of
merchantability or fitness for a particular purpose. Sika
shall not be liable under any legal theory for special or
consequential damages. Sika shall not be responsible for
the use of this product in a manner to infringe on any
patent or any other intellectual property rights held by
others. Sale of Sika products are subject to Sika's terms
and conditions of sale available at http://usa.sika.com/
or by calling 201-933-8800.
Product Data Sheet
Sikacryl® Ready-Mix Stucco Patch
June 2018, Version 01.01
020405030010000094
2 /
3