Product Data Sheet

Attach the static mixing nozzle.▪
Begin dispensing the cartridge’s contents through the
static mixing nozzle. Prior to installation, the initial por-
tion of material dispensed from the nozzle is discarded
until it can be visually verified that both components
are flowing and mixing to a uniform Gray appearance
and consistency.
▪
If cartridge is partially used and the remaining con-
tents is to be saved for a future application, leave the
static mixing nozzle mounted on the cartridge until that
later date. When ready to continue use, remove the
spent static mixing nozzle by twisting counterclockwise
and breaking the seal of the cured mortar. This may re-
quire the assistance of a pliers, wrench or similar tool.
Remove remnants of cured mortar with a utility knife
from the top of the openings in the plastic film to en-
sure fresh material is free to flow. Attach a new static
mixing nozzle and repeat the dipensing and application
procedures.
▪
APPLICATION
After confirming that a well blended mix is being dis-
pensed from the static mixing nozzle, fill the prepared
crack, cavity or void with Sikacryl® PowerSet gap filler.
Tooling and Finishing
Finish flush and strike even with the existing surface us-
ing a dry putty knife or small pointing trowel.
Removal
Uncured product can be cleaned immediately from in-
stallation tools and surfaces with a solvent such
as Acetone, MEK or Xylene. Cured mortar can only be re-
moved mechanically.
CLEANING OF TOOLS
Uncured product can be cleaned immediately from in-
stallation tools and surfaces with a solvent such as Acet-
one, MEK or Xylene. Cured mortar can only be removed
mechanically.
LIMITATIONS
Minimum recommended ambient and substrate tem-
perature is 40 °F (4 °C). Maximum recommended ambi-
ent and substrate temperature is 105 °F (41 °C) .
▪
Fully cured Sika PowerSet gap filler is not a flexible ma-
terial. Do not use in moving joints.
▪
Not formulated to be an aesthetically pleasing product.▪
Do not apply over a wet, glistening surface. Substrates
should be free of frost.
▪
May stain porous substrates. Test small mock-up in-
stallation in an inconspicuous location prior to proceed-
ing with entire project.
▪
Cured Sikacryl PowerSet gap filler may not permit cer-
tain types of paint and coatings from adhering well to
its surface. Mock-up and test for adhesion and compat-
ibility in an inconspicuous location before committing
to any paint or coating. Painting is not typically recom-
mended.
▪
BASIS OF PRODUCT DATA
Results may differ based upon statistical variations de-
pending upon mixing methods and equipment, temper-
ature, application methods, test methods, actual site
conditions and curing conditions.
LOCAL RESTRICTIONS
Prior to each use of any Sika product, the user must al-
ways read and follow the warnings and instructions on
the product’s most current Product Data Sheet, product
label and Safety Data Sheet which are available online at
http://usa.sika.com/ or by calling Sika's Technical Ser-
vice Department at 800.933.7452 nothing contained in
any Sika materials relieves the user of the obligation to
read and follow the warnings and instructions for each
Sika product for each Sika product as set forth in the cur-
rent Product Data Sheet, product label and Safety Data
Sheet prior to product use.
Product Data Sheet
Sikacryl® PowerSet
June 2018, Version 01.01
020405020030000013
3 /
4