TDS

Elongation at Break
600%
(ASTM D-412)
Tested at:
73 °F (23 °C)
50 % R.H.
Chemical Resistance
Good resistance to water, diluted acids, and diluted alkalines.
Consult Technical Service for specific data
Service Temperature
-40 to 170 °F (-4 to 77 °C)
Resistance to Weathering
Excellent
APPLICATION INFORMATION
Coverage
10.1 fl . oz. cartridge yields 12.2 lineal ft. of 1/2 in. x 1/4 in. bead
29 fl . oz. cartridge yields 35 lineal ft. of 1/2 in. x 1/4 in. bead
Ambient Air Temperature
40 to 100 °F (4 to 38 °C)
Cure Time
5 to 7 days
Skin Time
2 hours (depends on temperature and humidity)
(TT-S-00230C)
Tested at:
73 °F (23 °C)
50 % R.H.
APPLICATION INSTRUCTIONS
SUBSTRATE PREPARATION
Clean all surfaces. Surface must be sound, clean, dry,
frost-free, and free of oil and grease. Curing compound
residues and any other foreign matter must be
thoroughly removed.
Priming is not usually necessary for non-absorbent
materials such as anodized aluminum, steel, glass,
ceramics, stoneware and tiles.
APPLICATION METHOD / TOOLS
Recommended application temperatures: 40 to 100 °F (4
to 38 °C). For cold weather application, condition
material to 65 to 75 °F (18 to 24 °C) before using. Cut
plastic tip of nozzle to desired size and puncture airtight
seal at base of tip. Force adhesive onto bonding surface.
Use as spread, bead or for spot bonding. Heavier
substrates may require additional support during the
cure period.
LIMITATIONS
Allow a minimum of 1 week cure at standard
conditions when using SikaBond Construction
Adhesive, in total water immersion situations
▪
Low temperature and humidity will slow the cure of
the sealant
▪
Avoid exposure to high levels of chlorine. (Maximum
level is 5 ppm)
▪
Avoid contact with alcohol and other solvent cleaners
during cure
▪
Since system is moisture-cured, permit sufficient
exposure to air
▪
Can tend to yellow slightly when exposed to ultraviolet
rays
▪
Do not use on PVC based material▪
Will not bond to polyethylene, polypropylene, and
polystyrene
▪
Do not use on tar, bituminous or asphaltic-based
surfaces. Not for use in expansion joints
▪
Avoid contact with silicone or high solvent based
sealers/paints
▪
Preliminary tests are recommended prior to using on
porous decorative materials such as marble and other
natural stones (prevent staining)
▪
Product Data Sheet
SikaBond® Construction Adhesive
September 2018, Version 01.03
020513010000000011
2 /
3