User manual

VisualDepth for Visual Plus 320

the end of the text. If the curvature of the cylinder is different at the new location then

repeat from step 5. An easy way to check if the curvature is the same is to press the

probe against the good cylinder surface as in step 5 and check that the depth is reading

as 0.000in.

9. Once all pits have been measured press Enter to copy text from Recorded

Measurements box into the Visual Inspection form.

Inspecting the flat portion of the cylinder bottom

Measurement procedure (angled section of the cylinder bottom):

Use same procedure as in the beginning of this section with the following differences:

1. Set the probe handle wheel to letter E (always first move to B and then back to E).

2. When taking a measurement the probe should be moved down and slightly towards the

sidewall, instead of straight down.