Installation guide

For Existing Windows 2000 Installation

1. Install the board and boot up Windows 2000.

2. At the Found New Hardware Wizard, click Next.

3. Select Search for a suitable driver for my device

(recommended) and click Next.

4. Insert the driver diskette, check Floppy disk drives,

uncheck the other boxes, and click Next. Click Next

again to continue.

5. If the Digital Signature Not Found message appears,

click Yes. Our driver has been thoroughly tested in

Windows for stability.

6. If prompted for Windows 2000 CD-ROM, insert the

CD and click OK. Type in D:\I386, click OK and

Finish. (Assuming D: is your CD-ROM drive)

7. Click Finish, remove the driver diskette and restart

Windows to complete the driver installation.

Windows XP Driver Installation

For New Windows XP Installation

1. Install the board and follow Microsoft procedures to

install Windows XP accordingly.

2. Restart your system when prompted by Windows'

installation.

3. At the Windows Setup screen, press F6 to install the

driver.

4. Insert the driver diskette. Press S then press Enter.

5. Select Silicon Image SiI 3112 ... Controller and

press Enter.

6. Press Enter to continue and follow on-screen

instructions to complete Windows XP installation.