Installation guide

4. Insert the driver diskette, type in A:, then click OK.

5. Highlight Silicon Image SiI 3112 ... Controller and

click OK.

6. Click OK, remove the driver diskette and restart NT

to complete the driver installation.

Verify Windows NT4.0 Installation

1. Double click My Computer/Control Panel/SCSI

Adapters.

2. Highlight Silicon Image SiI 3112 ... Controller from

SCSI Adapters listing and click Properties. A

message This device is working properly is displayed

in the dialog box, the driver has been correctly

installed.

Windows 2000

For New Windows 2000 Installation

1. Install the board and follow Microsoft procedures to

install Windows 2000 accordingly.

2. Restart your system when prompted during

Windows' installation.

3. At the Windows 2000 Setup screen, press F6 to

install the driver.

4. Insert the driver diskette. Press S, then press Enter.

5. Select Silicon Image SiI 3112 ... Controller and

press Enter.

6. Press Enter to continue and follow on-screen

instructions to complete the installation.