Installation guide

Verify Windows 98/ME Installation

1. Right-click My Computer, then click Properties.

Select Device Manager tab.

2. Double click SCSI Controllers and Silicon Image

SiI 3112 ... Controller should be listed.

3. Highlight Silicon Image SiI 3112 ... Controller and

click Properties. A message This device is working

properly is displayed in the dialog box, the driver has

been correctly installed. If an error message is

displayed, remove Silicon Image SiI 3112 ...

Controller and restart your system.

Windows NT4.0

For New Windows NT4.0 Installation

1. Install the board and follow Microsoft procedures to

install Windows NT4.0 accordingly.

2. At the Windows NT Setup screen, press F6 to

specify and add the driver.

3. Press S, select Other, then press Enter.

4. Insert the driver diskette and press Enter.

5. Select Silicon Image SiI 3112 ... Controller and

press Enter.

6. Press Enter to continue and follow on-screen

instructions to complete Windows NT4.0

installation.

For Existing Windows NT4.0 Installation

1. Install the board and boot up Windows NT4.0.

2. Double click My Computer/Control Panel/SCSI

Adapters, then click the Drivers tab.

3. Click Add… then Have Disk....