Installation guide

5
Windows 98/98SE
For New Windows 98 Installation
1. Install the board and follow Microsoft procedures to
install Windows 98 accordingly.
2. Once Windows has been installed, right click My
Computer and click Properties. Select Device
Manager tab.
3. Double click PCI Mass Storage Controller listed
under Other Devices.
4. Select Driver tab, then click Update Driver button.
5. Insert the driver diskette and click Next.
6. Select Search for a better driver ... and click Next.
7. Check Floppy disk drives, uncheck the other boxes,
then click Next. Click Next again, then Finish.
8. Remove the driver diskette and restart Windows to
complete the driver installation.
For Existing Windows 98 Installation
1. Install the board and boot up Windows 98.
2. At the Add New Hardware Wizard, click Next.
3. Select Search for the best driver for your device and
click Next.
4. Insert the driver diskette, check Floppy disk drives,
uncheck the other boxes, then click Next.
5. Click Next, then Finish.
6. Remove the driver diskette and restart Windows to
complete the driver installation.