User`s manual

User's Manual
3-8
For an existing Windows 2000 Systems
1. After installing the board, boot up Windows 2000. Windows
will attempt to detect the controller.
2. When Found New Hardware Wizard appears, click Next to
continue.
3. Select Search for a suitable driver for my device
(recommended), then click Next.
4. Insert the Software Installation diskette into the floppy drive,
check Specify a location, click Next, type in A:. Click OK, then
Next to continue.
5. If the Digital Signature Not Found message appears, click Yes.
Note: If prompted for Windows 2000 CD-ROM, insert the CD
into your CD-ROM drive and click OK. Type in D:\I386
(assuming D: is your CD-ROM drive) and click OK and then
Finish.
6. Click Finish, remove the floppy disk, then click Yes to restart
Windows.
3-3.7 Verify Installation for Windows 2000
1. Go to My Computer/Control Panel/System.
2. Click Hardware, then click Device Manager.
3. Double click SCSI and RAID Controllers, then double click
CMD PCI-0649 Ultra 100 IDE RAID Controller to display
driver properties. A message This device is working properly is
displayed in the dialog box, the driver has been correctly
installed.
3-4 Medley GUI Installation
1. Place installation floppy into disk drive.
2. Click Start/Run. Type A:\installmedley.exe, then click OK.
3. Follow the onscreen directions to complete the installation.