User`s manual

Installation
3-5
3-3.2 Windows ME Installation
For a new Windows ME installation
1. Setup the RAID array prior to the Windows installation.
2. Follow Microsoft procedures to install Windows ME
accordingly.
3. Once Windows has installed, double click My Computer/
Control Panel/System. Select Device Manager tab.
4. Double click PCI RAID controller listed under Other Devices.
5. Select Driver tab and click Update Driver button.
6. Select Specify the location of the driver (Advanced), then
click Next.
7. Insert the Software Installation diskette into the floppy drive,
uncheck Removable Media (Floppy, CD-ROM...). Check
Specify a location, type A:, then click Next.
8. Click Next, then Finish.
9. Remove the Installation floppy, then click Yes to restart
Windows to complete the installation.
For an existing Windows ME installation
1. After installing the board, boot up Windows ME, the Add New
Hardware Wizard dialog box will appear.
2. Select Specify the location of the driver (Advanced), then click
Next.
3. Insert the Software Installation floppy. Uncheck Removable
Media (Floppy, CD-ROM...). Check Specify a location, type
A:, then click Next.
4. Click Next, then Finish.
5. Remove the floppy disk, then click Yes to restart Windows to
complete the installation.
3-3.3 Verify Installation for Win98/98SE/ME
1. Go to My Computer/Control Panel/System/Device Manager.
2. Double click SCSI Controllers, CMD PCI-0649 Ultra 100 IDE
RAID Controller is listed.