Installation guide

For An Existing Installation

1. Install the board and boot up Windows.

2. At the Found New Hardware window, click Locate

and install the driver automatically (recommended).

3. Insert the driver CD, click Continue.

4. Click Next, then click Close.

5. Remove the driver CD, shutdown Windows, and

setup your RAID array.

When Windows resumes, go to SATARaid5 GUI on

page 19 and install the RAID monitoring utility.

To Verify Windows Vista Installation

1. Right click Computer, click Manage, click Continue,

select Device Manager.

2. Double click Storage controllers, and Silicon Image

SiI 3114 SoftRaid5 Controller should be displayed.

SATARaid5 GUI

The SATARaid5 GUI provides the user an easy way to

monitor your RAID set.

SATARaid5 GUI Installation

Important: Windows 2000 SP4 or later is required for

installation.

1. Insert the driver installation CD.

2. At the Windows desktop click Start:

For 2000: Click Run, type D:\32bitgui.msi, then

click OK. (Change D: to match your CD-ROM drive

letter)