Installation guide

Device Connection

The Serial ATA 4-Channel PCI-M is a four channel Serial

ATA controller that supports up to four Serial ATA hard

disk drives. If you plan to use more than two Serial ATA

channels, you will need to purchase additional Serial

ATA power and data cables.

1. Install hard disk drive(s) in chassis.

Note: Users with Mac OS X (v10.1.x) installed go to

Mac OS X (v10.1.x) Firmware Update on page 4

before proceeding.

2. Connect the hard disk drive to the system power

supply using the Serial ATA power cable.

3. Connect one end of the Serial ATA cable to the hard

disk drive.

Serial ATA cable

Serial ATA power cable

Figure 2. Hard disk drive connections

4. Attach the other end of the Serial ATA cable to a Serial

ATA connector on the Serial ATA 4-Channel PCI-M.

5. Follow the same instructions when connecting each

hard drive. Device connection is now complete.

6. Close the computer's case then go to Software

Installation to complete the installation.