User Manual

3
1. Turn OFF the power to your computer and any
other connected peripheral devices.
2. Unplug the power cord from the computer. Remove
the computer cover.
3. Remove the slot bracket from an available PCIe slot.
4. To install the card, carefully align the card's bus
connector with the selected PCIe slot on the
motherboard. Push the board down firmly, but
gently, until it is well seated.
5. Replace the slot bracket holding screw to secure the
card.
Device Connection
The DP SATA II PCIe is a dual channel Serial ATA II
controller that supports up to two Serial ATA hard disk
drives. If you plan to use the second channel, you will
need to purchase another SATA data cable.
1. Install your Serial ATA hard disk drive(s) into the
chassis.
2. Connect the hard disk drive to the system power
supply.
3. Connect one end of the SATA data cable to the hard
disk drive.
Figure 2. Hard disk drive connections
SATA data cable