User Manual

11
For 64-bit: Type D:\64bit\AMD64
(Change D: to match your CD/DVD-ROM drive
letter)
5. Click Next, and click Finish to complete the
installation.
Windows 2000
New Windows 2000 Installation
A floppy disk for the driver installation is required. Copy
the contents of Floppy folder in the driver CD to your
blank floppy disk. Then follow the directions below:
1. Install the board and follow Microsoft procedures
to install Windows 2000 accordingly.
2. At the Windows 2000 Setup screen, press F6.
3. Insert the driver floppy disk you made above. Press
S, then press Enter.
4. Select Silicon Image SiI 3132 ... Controller for
Windows 2000 and press Enter.
5. Press Enter again to continue and follow the on-
screen instructions to complete the installation.
Existing Windows 2000 Installation
1. Install the board and boot up Windows 2000.
2. At the Found New Hardware Wizard, click Next.
3. Select Search for a suitable driver for my device
(recommended), and click Next.
4. Insert the driver CD, check Specify a location,
uncheck the other boxes, click Next.
5. Type D:\Floppy , click OK, and click Next.
(Change D: to match your CD/DVD-ROM drive
letter)
6. Click Finish to complete the installation.