User Manual

3. Insert the driver floppy disk you made above. Press

S, then press Enter.

4. Select Silicon Image SiI 3132 ... Controller for

Windows XP and Server 2003, then press Enter.

5. Press Enter again and follow the on-screen

instructions to complete the installation.

New Windows XP (64-bit) / 2003 (64-bit) Installation

A floppy disk for the driver installation is required. Copy

the contents of the 64bit folder in the driver CD to your

blank floppy disk.Then follow the directions below:

1. Install the board and follow Microsoft procedures

to install Windows accordingly.

2. At the Windows Setup screen, press F6 to continue.

3. Insert the driver floppy disk you made above. When

prompted, press S, then press Enter.

4. Select Silicon Image SiI 3132 ... Controller (64-bit

Extended), and press Enter.

5. Press Enter again to continue and follow the on-

screen instructions to complete the installation.

Existing Windows XP (32-/64-bit) / 2003 (32-/64-bit)

Installation

1. Install the board and boot up Windows.

2. Insert the driver CD.

3. At the Found New Hardware, select No, not this

time, click Next. Skip this step if not prompted.

3. Select Install from a list or a specific location

(Advanced), then click Next.

4. Check Include this location in the search, uncheck

the other box.

For 32-bit: Type D:\Floppy