Installation guide

10
2. Select New_VD, press Enter. Select Delete
then press Enter.
3. When asked Do you want to delete this
virtual disk? press Y to select Yes.
4. When asked Do you want to delete MBR
from this virtual disk? press Y to select
Yes.
5. Press F10 to exit the BIOS. When asked Do
you want to exit from Marvell BIOS setup?
press Y to exit and reboot.
Driver Installation
This section provides information on how to
install the drivers.
Windows 8 (32-/64-bit) / Windows 7 (32-/
64-bit) / Server 2008 R2
For New Installation
1. Setup the RAID array prior to Windows
installation. If RAID is not required, go
directly to step 2.
2. Follow Windows installation procedure.