Installation guide

13
5. Click Finish. Remove the driver CD, then restart
Windows to complete the installation.
When Windows resumes, go to SATARaid GUI on page
15 and install the RAID monitoring utility.
Windows XP/Server 2003
A new installation of Windows XP and Server 2003
requires a floppy disk for the driver installation. To
make this floppy disk, copy the contents of the Floppy
folder, found on the driver CD, onto a blank floppy disk
then follow the directions below.
1. Setup the RAID array prior to Windows installation.
2. Follow Microsoft's Windows installation procedure.
3. Restart the computer when prompted by Windows'
installation.
4. At the Windows Setup screen, press F6 to install the
driver.
5. When prompted press S to specify the location of
the driver.
6. Insert the driver diskette, then press Enter.
7. Select Silicon Image Sil 3x12 SATARaid Controller
for Windows XP/Server 2003, then press Enter.
8. Press Enter to finish driver installation, then follow
the on-screen instructions to complete Windows
installation.
When Windows installation completes, go to SATARaid
GUI on page 15 and install the RAID monitoring utility.