Installation guide

2
• Network Interface:
Models:
4000-ST : Four 100Base-FX, ST (multi-mode)
4000-SC: Four 100Base-FX, SC (multi-mode)
4000-MT: Four 100Base-FX, MT-RJ (multi-mode)
8020-ST: Eight 10/100Base-TX; RJ-45
Two 100Base-FX, ST (multi-mode)
8020-SC: Eight 10/100Base-TX; RJ-45
Two 100Base-FX, SC (multi-mode)
• Fiber Optic Connector:
ST/SC/MT-RJ connector (multi-mode), Tx/Rx
• Fiber Optic Cable and Maximum Length:
50/125, 62.5/125 or 100/140 µm (multi-mode); up to 2000 m
• TP Connector: (For models 8020-ST and 8020-SC only)
• Selectable Duplex Mode Switch: Per fiber port FDX/HDX
DIP switch
• LED Indicators:
LED Color Function
Link/Act Green Lit when remote device connection is good
Blinks when any traffic is present
100Mbps Green Lit when 100Mbps speed is active
FDX/Col Amber Lit when full-duplex mode is active
Blinks when collision signal is present
POWER Green Lit when AC power is ON and good
• Power Requirement:
AC Voltage: 100~240V
Frequency: 50~60Hz
Consumptions: Models 4000-ST/SC/MT: 25W Max.
Models 8020-ST/SC: 43W Max.
• Operating Temperature: 32° to 122° (0° to 50°C)
• Storage Temperature: -40° to 158°F (-40° to 70°C)
• Relative Humidity: 5% to 90%, non-condensing
• Dimensions:
Models 4000-ST/SC/MT: 45mm (H) x 330 (W) x 200mm (D)
Models 8020-ST/SC: 46mm (H) x 440 (W) x 220mm (D)