Installation guide

6
Windows NT 4.0
Perform the steps listed below to install the following Windows NT 4.0
driver files:
Location of Driver: A:\WINNT\DC21X4.SYS
\OEMSETUP.INF
1. In “My Computer” of NT desktop, select the “Control Panel” icon.
2. In the Control Panel window, double-click on the “Network” icon.
3. In the Network Settings dialog box, choose “Adapters”, then click
the “Add” button.
4. Click on “Have Disk” and insert the Windows Driver Installation
Diskette 1 into the floppy drive.
5. Type a:\winnt and click "OK".
6. Click "OK" when the "100Fx Fast Ethernet Adapter" is displayed.
7. NT will then perform the binding process. If any additional
network software options were installed, you may be prompted for
specific information for these packages. Click "OK" when the dialogue
box shows "100 Base-Fx (Fx100) Full Duplex".
8. Enter settings and restart your system to acquire network service.
Note: The FiberOptic Cards support 100Mbps speed only. You may
select 100 Full-duplex or Half-duplex mode configuration for
connection type. The default is 100 Full-duplex mode.
An invalid connection type will not work in network connection.
Windows 2000
Windows 2000 will automatically load the driver for this adapter. If you
are prompted to insert the Windows 2000 CD, insert the CD in the
CD-ROM drive and "browse" to the I386 folder to finish the installation.
Other OSes
Please refer to the appropriate read.me file on the driver
installation diskettes for installation instructions. These files can be
opened with either Notepad or Wordpad.