Installation guide

Windows 98/98SE

Perform the steps below to install the Windows 98 driver files,

which are built into Windows98/98SE.

1. When Windows 98/98SE boots up after installing the card,

a "New Hardware Found" dialog box will appear and the

detected Ethernet Adapter will be identified.

2. At the "Add New Hardware Wizard" window, click "Next".

3. Select the “Search for the best driver for your device

(Recommended)" option. Click “Next” to continue.

4. "Uncheck" all option boxes. Click "Next" and click "Next" again.

5. Click "Next" again. When prompted for the Windows

CD, insert the Windows 98 CD into the CD-ROM drive.

Type D:\win98 and click "OK". (Assuming "D" is the CD-ROM

drive letter.)

6. Click on "Finish" and restart the system when prompted for the

driver to take effect.

Note: The FiberOptic Cards support 100Mbps speed only. You may

select 100 full-duplex or half-duplex mode configuration for

connection type. The default is 100 full-duplex mode.

An invalid connection type will not work in network connection.