Installation guide

7
4. Switch the Power Source Switch to "USB/
Battery" when powering up the Adapter
through USB or Battery.
Switch the Power Source Switch to "DB9-
Pin9 (5V)" when powering up the Adapter
through powered DB9.
5. The Power LED shows steady red light
indicating the power is on. Once power is
confirmed, go to the next section for COM
port configuration and connection.
COM Port Configuration
1. Configure the parameters of the COM port
through HyperTerminal or other terminal
software. To configure the adapter,
initiate HyperTerminal from the Start Menu.
Note: The configuration windows below
come from software HyperTerminal. For
other terminal software, the windows may
be slightly different.
2. Type in "Name", then click OK. See Figure
6.