Installation guide

18
STOP=
Used to specify one or two stop bits of COM port. (Will have
200ms delay.)
(Default) 1 One stop bit.
2Two stop bits.
? Inquire the current setting.
VERSION= Used to inquire the firmware version.
? Inquire the version codes.
Command is not available under following status:
1ROLE=S
SEARCH=? , CONNECT=?, CONNECT=P ,
CONNECT=xxxxxxxxxxxx , CONNECT=DEVICE
2AUTO=Y
SEARCH=? , CONNECT=? , CONNECT=P ,
CONNECT=xxxxxxxxxxxx , CONNECT=DEVICE
3DIP=Y
ROLE=M, ROLE=S , AUTO=Y , AUTO=N
,DISCOVER=Y,DISCOVER=N
4 <<<
SEARCH=? , CONNECT=? , CONNECT=P ,
CONNECT=xxxxxxxxxxxx , CONNECT=DEVICE
5 >>>
SEARCH=? , CONNECT=? , CONNECT=P ,
CONNECT=xxxxxxxxxxxx , CONNECT=DEVICE
6 Not connection RSSI=? , CONNECT=Y , CONNECT=N
Pin Assignment