Installation guide

15
R
Restore the status in which the adapter can connect with any
remote address.
? Inquiry the designated address that can be paired and connected.
DIP= Set the DIP switch function.
? Inquire the setting status of the DIP switch function.
Y
Turn on the function of the DIP switch. The "ROLE" and "AUTO"
command are not available to set the "Master" or "Slave".
(Default) N
Turn off the function of the DIP switch. The "ROLE" and "AUTO"
command are available when the DIP=N.
DISCOVER-
=
Used to specify whether the adapter can be discovered or
connected by remote devices.
This command is available only when the adapter is in the slave
role.
N
The adapter enters the undiscoverable mode. If a pair has been
made, the original connection can be resumed. But other remote
master device cannot discover this adapter.
(Default) Y The adapter enters the discoverable mode.
? Inquire the current setting.
ECHO=
This command is used to specify whether the adapter echoes
characters received from the UART back to the DTE/DCE.
N
Command characters received from the UART are not echoed
back to the DTE/DCE.
(Default) Y
Command characters received from the UART are echoed back to
the DTE/DCE.
? Inquire the current setting.
FLOW=
This command enable or disable flow control signals (CTS/RTS)
of the UART port. Note: the setting is not affected by DEFAULT.
The command will need 1 second delay.
(Default) N Disable flow control.
Y Enable flow control.
? Inquire the current setting