Installation guide

10
3. DTE & DCE Switch.
Use the DTE/DCE Switch to swap between
DTE/DCE. By switching, you can set the
adapter as a DTE (towards antenna
connector) or a DCE (towards RS232
connector).
4. Set up the Group mode.
The adapter is in N/G mode by default. The
adapter can be set to G mode if you have
more than two RS-232 Serial to Bluetooth
Adapters, meaning this adapter is able to
perform single to multiple transmission.
Follow the steps to set the adapter to Group
mode by terminal software:
2.2. Using the "DIP" command.
The default is DIP=N. Type DIP=Y to turn
on the function of the DIP switch, then you
can manually adjust the S/M switch to
change it to master or slave mode.