Installation guide

In order for the USB 3.0 & 2.0 Hub Card Reader to

work as a USB 3.0 hub, the driver for your

existing USB 3.0 host controller has to be properly

installed. This hub will automatically be detected

and installed when connected to the USB 3.0

port.

1. Connect the Type-B connector of the

included USB 3.0 cable to the Upstream

port (Root Port, Type-B) of the USB 3.0 &

2.0 Hub Card Reader.

2. Connect the Switching power adapter into

the Power jack of the USB 3.0 & 2.0 Hub

Card Reader, then plug the power adapter

into a reliable power source.

3. Plug the Type-A connector of the included

USB 3.0 cable into an available USB port

(USB 3.0 recommended), and the driver

will install automatically.

4. The USB 3.0 & 2.0 Hub Card Reader is ready

for use.