Installation guide

2. Double click Universal Serial Bus controllers and the

following options should be displayed, in addition to others

that may come with your system.

- NEC ... USB Open Host Controller ...

- NEC ... USB Enhanced Host Controller

- USB 2.0 Root Hub Device

- USB Root Hub

3. If these options DO NOT appear:

a. Look for USB controller(s) under Other Devices with

yellow exclaimation marks (!), remove them and restart

your system. Refer to software installation section to re-

install the driver.

b. If there's no USB controller under Other Devices, shut

down your system, remove the board and re-insert it in the

same or a different PCI slot. Make sure the board is

properly seated in the PCI slot. Boot up your system and

refer to software installation section to re-install the

driver.