Installation guide

5. The board is now ready for use.

Windows XP Driver Installation

If you have have XP Service Pack 1 or later installed, Windows will

automatically detect and install the correct driver for this board.

Otherwise, follow all steps below.

1. After installing the board, boot up to Windows. At the Found

New Hardware Wizard, click Cancel.

2. Click Start, Run, insert the driver diskette, type

A:\setup206.exe, then click OK.

3. At the Software Installation window click Continue Anyway.

Our driver has been thoroughly tested in Windows for stability.

This message appears because Microsoft has not tested this product

through WHQL certification.

4. Click Close to restart and remove the driver diskette.

5. At the Found New Hardware Wizard, select Install the

software automatically (Recommended), then click Next.

6. At the Hardware Installation window, click Continue anway,

then click Finish.

7. Windows now detects the USB 2.0 Hub and prompts you to

load it's driver.

8. Repeat steps 5 and 6.

9. The board is now ready for use.

To verify successful driver installation:

1. Check Device Manager to verify successful driver installation.

Windows 98SE/ME: From the main desktop, right click My

Computer, then click Properties. Click Device Manager tab.

Windows 2000/XP: Right click My Computer, then click

Manage. Click Device Manager.