Installation guide

3
• Turn OFF the power to your computer and any other
connected peripheral devices. Unplug the computer's power
cord.
• Remove your computer’s cover and install the card in an
available PCI slot.
• Push the board down firmly, but gently, until it is well seated.
• Connect an available 4-pin power connector from the system
power supply to the 4-pin power connector on the FireWire
800 32-bit PCI board (See figure 1). This connection is
recommended for reliable power output.
• Secure the card and replace the cover.
Software Installation
This section provides information on how to install the FireWire 800
32-bit PCI drivers. Please follow the directions below for your
operating system.
Windows Driver Installation
For Windows 98SE
1. At the Add New Hardware Wizard, click Next.
2. Select Search for the best driver for your device
(Recommended), then click Next.
3. Insert the driver CD, check CD-ROM drive, uncheck the
other boxes, then click Next.
4. Click Next, then Next again.
5. If prompted for the Windows 98SE CD, insert it, then click OK.
6. Click Finish and restart Windows to complete the installation.
For Windows ME
1. At the Add New Hardware Wizard, insert the driver CD,
select Automatic Search for a better driver, then click Next.
2. Click Finish.
3. Click Yes to restart Windows and complete the installation.