Installation guide

3. Click the 1394 adapter that you want to switch, then

click on Microsoft 1394 Drivers.

Note: If your system has multiple 1394 adapters

installed, make sure that you click on the 1394

adapter that the camcorder will be plugged into.

4. Windows will display an information box when the

driver is ready for use. It may take a few seconds for

this box to appear. Wait for this box to appear then

connect your DV camcorder.

Note: To switch back to the FireWire 800 driver,

follow the same procedures, but in step 3 instead of

clicking on Microsoft 1394 Drivers, click on Unibrain

1394 Drivers.

Connecting a DV Camcorder

Before setting up the digital video camcorder, verify that

the Microsoft FireWire 400 driver has been successfully

installed in your system, then follow the steps below.

1. Connect the 4-pin connector of your FireWire 400

DV cable to your camcorder.

2. Connect the 6-pin connector of the DV cable to the

FireWire 400 port.

3. Power on the camcorder. The camcorder should

appear in Device Manager.

Verify DV Camcorder Setup

1. Right click My Computer, click Manage, then click

Device Manager.

2. Double click Imaging Device(s). Microsoft DV

Camera and VCR or DV Camcorder should be

displayed.