Installation guide

2
Layout
Figure 1. Layout
Note: FireWire devices that have their own power
supply do not require the optional power adapter
to be connected in order to work. However,
non-powered FireWire devices require this
optional power adapter to work. The power
adapter can be purchased at SIIG's Online Store.
Hardware Installation
General instructions for installing the card are provided
below. Since the design of notebook computers may
vary, refer to your system’s reference manual for further
information, if needed.
1. Power off your notebook computer and any other
connected peripheral devices.
2. Insert the PC Card into the CardBus Type II slot of
your notebook computer with its 68-pin connector
facing the slot. Make sure it is inserted all the way
in for a solid connection.
3. Power on your notebook computer.
FireWire 400
(6-pin)
Power Adapter Jack
FireWire 800
(9-pin)
Activity LED