Installation guide

Windows Vista

(32-/64-bit) / Server 2008 (32-/64-

bit)

1. Install the board then boot up Windows.

2. At the Found New Hardware window, click Cancel.

3. Insert the Software CD:

At the AutoPlay window: Click Open folder to

view files. Double click Setup.

If AutoPlay doesn't start: Click Start, in the Start

Search box, type D:\setup.exe, press Enter.

(Change D: to match your CD-ROM drive letter)

4. Click Allow. Skip this step if not prompted.

5. Select Yes, I want to restart my computer now,

then click Finish.

Windows XP (32-/64-bit) / Server 2003 (32-/64-

bit) / 2000

1. Install the board then boot up in Windows.

2. At the Found New Hardware Wizard, click Cancel.

3. Insert the Software CD. Close the CD autoplay box

if prompted.

4. Click Start, Run, type D:\setup.exe, then click

OK. (Change D: to match your CD-ROM drive

letter)

5. Click Next two times.

6. Select Yes, I want to restart my computer now,

then click Finish.