Installation guide

11
Firmware Update
Note: If the Scaler Software is not installed, go to
Scaler Software on page 6 now and follow the
instructions to install it. Otherwise, follow the
instruction below to update the firmware.
1. Connect the Scaler to your computer using
a USB cable (cable not included), double
click the Scaler software icon.
2. Enter the Scaler software main menu, select
a COM port and click Refresh to make the
connection.
3. Click System button, then click Firmware
Update.
4. Click Load file, select the firmware file.
5. Set the DIP Switch up to F/W, unplug and
plug the Scaler's power adapter.
6. Click Burn. Wait for the firmware update
process to complete.
7. Power off the Scaler, unplug the USB cable
from the computer, then set the DIP Switch
back to Normal. The firmware update is
now complete.