User`s manual

2-7
Installation
CB10xsu.exe
Speed Change
The default baud rate for the Cyber 2S1P's serial port is
115.2Kbps. If you connect a higher speed device, you may
change the baud rate to support up to 460Kbps for
Cyber 2S1P PCI or 920Kbps for Cyber 2S1P Plus.
Note: To switch to 460/920Kbps only when
using a device that supports a baud rate faster
than 115.2Kbps. Any device supports the
speed less than 115.2Kbps should be kept at
default setting.
Perform the following steps to change the baud rate speed:
1. Go to My Computer in Windows 95 and click on the
subdirectory where the DOS utility files are stored. If it is
from the floppy disk, insert Driver Installation diskette and
double-click on “3 1/2 Floppy (A:)”and press <Enter>. Then
double-click on the “DOS” folder and press <Enter>.
2. Double-click on the file cb10xsu.exe and press <Enter>.
The first screen displays the current mode setting, for
example: Serial port, Baud Rate=Low
3. To change the mode setting, type the letter “C” and press
<Enter>.
4. Type "H" and press <Enter> to change to high baud rate.
5. Type "Q" and press <Enter> to quit.
6. Restart your system for the change to take effect.