User`s manual

2-6
Cyber 2S1P User's Manual
2-2.3 DOS/Windows 3.x Utilities
For DOS support, run the dosinst.bat file to copy DOS
driver files cb10xpc.exe, cb10xsu.exe and dosinst.bat to
subdirectory c:\siig\cb10x> on drive C.
1. Insert Driver Installation diskette in the floppy drive.
2. From the C:\> prompt, type a: and press <Enter>.
3. From the A:\> prompt, type cd dos and press <Enter>.
4. From the A:\DOS> prompt, type dosinst and press
<Enter> to copy the files to subdirectory c:\siig\cb10x.
5. Remove the floppy diskette.
2-2.4 DOS Utilities
The following two DOS utilities are provided in the DOS
subdirectory of the Driver Installation diskette:
CB10xpc.exe To display the current configuration setting
of the speed of baud rate for the serial port and
the I/O port address and mode setting for the
parallel port.
CB10xsu.exe To change the speed of baud rate for the serial
port and the mode setting for the parallel port.
You can either run the utilities from the diskette, or copy them
to a subdirectory on your hard drive.
CB10xpc.exe
The default baud rate for your Cyber 2S1P's serial port is
115.2Kbps. And the I/O port address and mode setting for the
parallel port are automatically assigned during the system's
startup. If you like to view the current system setting for the
Cyber 2S1P, proceed with the following instruction to run the
CB10xpc.exe:
• Go to My Computer in Windows 95 and click on the
subdirectory where the DOS utility files are stored. If it is
from the floppy disk, insert Driver Installation diskette and
double-click on “3 1/2 Floppy (A:)”, “DOS” folder and the
file cb10xpc.exe to display the current settings.