User`s manual

2-5
Installation
2-2.2 Windows NT 4.0 Driver Installation
The Windows NT 4.0 drivers and associated files reside in
the NT subdirectory on the Driver Installation diskette.
Perform the following steps to install the Windows NT 4.0
drivers.
1 Boot up from Microsoft Windows NT 4.0.
2. Insert the Driver Installation diskette in the floppy drive.
3. From the desktop, double-click on My Computer, then
3 1/2 Floppy (A:) and NT subdirectory.
4. Double-click on the setup icon. When the program
opens to the “SIIG Cyber PCI Welcome” window, click on
Next to continue.
5. From the “Choose Destination Location” window, click
Next to install the driver files in the default folder. Or
click Browse to change, then click Next to proceed.
6. From the next “Setup Complete” window, click Finish.
7. Remove the diskette and click on Finish to reboot your
system.
To verify successful installation:
1. From the main desktop, click on My Computer, then
Control Panel.
2. Double-click on the SIIG Cyber PCI icon. The assigned
system configuration will be displayed.
Note: During system startup after installing the
board, a non-conflicting system setting such as
COM port and base I/O address will be assigned.
If you like to change it to a specific setting, you can
override the assigned setting by going into the
Control Panel, SIIG Cyber PCI, Settings, then
Advanced to change it.