User`s manual

2-4
Cyber 2S1P User's Manual
2-2 Installing the Drivers and Utilities
This section provides information on how to install the
Cyber 2S1P's drivers and utilities for the following
operating systems:
Windows 95/98
Windows NT 4.0
DOS/Windows 3.x
IMPORTANT
Make sure you have installed the Cyber 2S1P
in your system BEFORE installing the software.
2-2.1 Windows 95 & 98 Driver Installation
Perform the following steps to install the drivers for
Windows 95/98:
1. When you first turn on your computer after installing the
Cyber 2S1P, Windows will notify you of “New Hardware
Found”. From the choices listed on the screen, select:
“• Driver from disk provided by hardware manufacturer”
and click OK.
2. Insert the Driver Installation diskette in the floppy drive
and click OK.
3. Make sure the path in the command line window is
A:\. Then, click on OK to install the driver files.
4. Remove the diskette and select Yes to restart your
computer to finish setting up the new hardware.
To verify successful installation:
1. From the main desktop, click on My Computer, then double-
click on Control Panel, System, and Device Manager.
2. Double-click on SIIG Cyber PCI device options. SIIG
Cyber 2S1P Board should be displayed when successfully
installed. The port is ready to connect your new device.