User`s manual

2-3
Installation
NOTE: Hold the card by its external edges
only. Try to avoid touching the components,
connectors or pins.
Fig. 2-2. Install the Cyber 2S1P and
the connector bracket
8. Replace the slot bracket holding screws to secure the
board and the connector bracket to the rear slot panels.
9. Connect the connector on the bracket mounted parallel
port's ribbon cable to the 26-pin connector on the Cyber
2S1P. Make sure pin 1 of the ribbon cable (the side
imprinted with color stripe) matches with pin 1 of the
on-board connector (indicated by a silk screened num-
ber 1).
10. Replace the computer's cover.
11. Reconnect the power cord and make new connections to
the ports.
The hardware installation is now complete. Continue to the
next section for the installation of the driver and utility files.