User`s manual

2-2
Cyber 2S1P User's Manual
2. Unplug the power cord from the back of the computer.
3. Remove the computer’s cover.
4. Select an available 32-bit PCI slot for the new card.
NOTE
If you intend to install the DB25 parallel port
connector bracket, select an I/O expansion slot with
an adjacent slot for installing the connector bracket.
5. Remove the selected slot brackets by unscrewing the hold-
ing screws and sliding them out. Save the screws for se-
curing the Cyber 2S1P and the connector bracket after they
are installed.
Fig. 2-1. Remove the Slot Bracket
6. To install the Cyber 2S1P, carefully align the board’s bus
connector with the selected expansion slot on the
motherboard. Push the board down firmly, but gently,
until it is well seated.
7. To install the DB25 parallel port connector bracket,
carefully slide it into the slot where the slot bracket had
been removed.