Installation guide

Duplicate Disk

The Duplicate function creates an exact copy of the

source hard disk drive onto the target hard disk drive.

This is a standalone function and works without

computer connection.

1. Unplug the Cool USB 2.0/eSATA to SATA Docking

Duplicator from the computer.

2. Install the source hard disk drive and target hard

disk drive into the appropriate drive bay. The

target hard disk drive must be of equal or larger

capacity than the source hard disk drive.

3. Power on the Cool USB 2.0/eSATA to SATA Docking

Duplicator.

4. Press the Duplicate button, the upper Power LED

will flash for several seconds. When the flashing

stops, press the Duplicate button again to start the

duplication process. All 4 LEDs will light up

confirming duplication process is running. Do not

turn off or unplug the hard drives during the

duplication process.

Note: Typically, a 1TB hard disk drive will duplicate

in 4 hours (70MB/s average transfer rate) and a

500GB hard disk drive will duplicate in 1.25 hours

(110MB/s average transfer rate). Your results will

vary according to the speed and capacity of your

hard disk drives.

5. When the duplication process completes, only the

bottom Power LED will be on.

6. Power off the Cool USB 2.0/eSATA to SATA Docking

Duplicator and remove the target hard disk drive.