Installation guide

3
Hardware Installation
1. Boot up the computer.
2. Make sure the SATA connector of the Cool USB 2.0/
eSATA to SATA Docking Duplicator and SATA hard
disk drive are in alignment. Gently insert the hard
disk drive(s) into the SATA drive slot of the Cool
USB 2.0/eSATA to SATA Docking Duplicator.
3. Plug the included switching power adapter into
the power adapter jack of the Cool USB 2.0/eSATA
to SATA Docking Duplicator, then plug the switching
power adapter into a reliable power source.
4. Use either the included USB 2.0 cable OR eSATA
cable to plug the Cool USB 2.0/eSATA to SATA
Docking Duplicator into the computer.
Note:
Do not connect both USB 2.0 cable and eSATA
cable at the same time. Plugging in both cables at
the same time may damage the device or computer.
5. Make sure the operating system has fully started
before proceeding. Power on the Cool USB 2.0/
eSATA to SATA Docking Duplicator, make sure that
the 2 Power LEDs are lit.
Driver Installation
Windows and Mac operating systems will automatically
detect and install the drivers for the Cool USB 2.0/eSATA
to SATA Docking Duplicator. No additional driver
installation is needed. Important: In order to get high
speed USB 2.0 performance, make sure your USB 2.0
controller has the correct drivers installed.