Installation guide

6
4. Connect remote DisplayPort display (such as a LCD
TV) to the receiver's DP OUT connector.
output
display
Figure 5
5. Connect the IR blaster cable and IR receiver cable
to the Transmitter and Receiver's IR ports separately.
Skip this step if not needed.
6. Connect the two 3.5mm to RS-232 cables to the
Transmitter and Receiver's RS-232 ports separately.
Skip this step if RS-232 controlling is not needed.
7. Connect your CAT5/6 cable between the
Transmitter's and Receiver's LINE port. Make sure
the CAT5/6 LAN cable is securely connected.
Figure 6
remote
output
display
local
output
display
source
device
8. Each Receiver/Repeater can cascade-chainable to 2
more Receivers/Repeaters for further extending or
expanding . Skip this step if not needed.
9. Connect the speakers to the Transmitter and Receiver's
audio out ports separately.
Skip this step if not needed.
CAT5/
6 cable