Installation guide

5
IR Extension Cables
To control the source device from Receiver's end:
1. Plug the IR blaster cable to the Transmitter's IR
connector, then plug the IR receiver cable to the
Receiver's IR connector.
2. Point your source device's remote control to the IR
receiver's eye, the command will be sent to
Transmitter end, and the connected source device
will enforce the command accordingly.
Figure 3a: IR blaster cable Figure 3b: IR receiver cable
Hardware Installation
1. Power off all devices, including the source device
and display.
2. Connect your DisplayPort source (such as a PC or
NB) to the transmitter's DP IN connector by using a
DisplayPort cable.
3. Connect the local DisplayPort display to Transmitter's
DP OUT.
source
device
Figure 4
local
display