Installation guide

4
• DC 5V: DC 5V power jack. Plug the included power
adapter here
• IR: Connect to the included IR receiver cable
• RESET: Use the fine end of any object to press and
hold the bottom to return to default settings
• PWR: LED indicator for power status. On/Off when
the Receiver is powered on/off
• LINK: LED indicator for link status. On when the
connection of Transmitter and Receiver/Repeater is
established and detected
• RS-232: RS-232 control port. Plug the included
3.5mm to RS-232 cable then an RS-232 cable here, if
needed
• DP OUT: DisplayPort signal output port. Connect
this port to the remote DisplayPort display by using
a DisplayPort cable (not included)
• : Audio output port. Connect to the a remote
3.5mm audio speaker by using the included audio
cable
• LINE 1-3: Signal input port, connected with
Transmitter's LINE port by using a CAT X cable (not
included).
Either one port is connected to the Transmitter unit,
the other two ports could be connected to other
Receivers/Repeaters for further signal extension or
expansion. See the Function Diagram section on
page 7-10 for more details