Installation guide

• LINK: LED indicator for link status. On when the

connection of Transmitter and Receiver is established

and detected

• DP IN: DisplayPort signal input port. Connect this

port to your DisplayPort source device by using a

DisplayPort cable (not included)

• DP OUT: DisplayPort signal output port. Connect

this port to a local DisplayPort display by using a

DisplayPort cable (not included)

• : Audio output port. Connect to the a local

3.5mm audio speaker by using the included audio

cable

• LINE : Signal output port, connected with Receiver's

LINE port by using a CAT X cable (not included)

• IR: Connect to the included IR blaster cable

• RS-232: RS-232 control port. Plug the included

3.5mm to RS-232 cable then an RS-232 cable here, if

needed

• RESET: Use the fine end of any object to press and

hold the bottom to return to default settings

Receiver / Repeater Unit (Rx)

Figure 2: Receiver/Repeater side panel