Installation guide

5
Driver Installation
Windows 2000
1. Install the board then boot up in Windows.
2. At the Found New Hardware Wizard, click Cancel.
3. Insert the Software CD. Click Start, Run, type
D:\2K\setup.exe, then click OK. (Change D: to
match your CD-ROM drive letter)
4. Click Next three times.
5. Select Yes, I want to restart my computer now,
then click Finish.
Windows XP/Server 2003 (32-bit)
1. Install the board then boot up in Windows.
2. At the Found New Hardware Wizard, click Cancel.
3. Insert the Software CD. Click Start, Run, type
D:\XP_2003\setup.exe, then click OK. (Change
D: to match your CD-ROM drive letter).
4. Click Next three times.
5. Select Yes, I want to restart my computer now,
then click Finish.
Windows XP/Server 2003 (64-bit)
1. Install the board then boot up in Windows.
2. At the Found New Hardware Wizard, click Cancel.
3. Insert the Software CD. Click Start, Run, type
D:\XP_2003 x64\setup.exe, then click OK. (Change
D: to match your CD-ROM drive letter).
4. Click Next three times.
5. Select Yes, I want to restart my computer now,
then click Finish.