i SIG" 4K60Hz HDMI over IP Extender with IR & ARC Kit User Manual iE 5 P/N: CE-H27H11-51 04-1390A P/N:
Features Support HDMI 4K@60 4:4:4 Bits Support PHD 2.2 & 1.4 Support HDR which Is 4K2K@60 4:2:¢ bits Extend 4K@60Hz video up to 328ft/100m through a Catboat network cable Support one to many connection through the Gigabit Network Switch Support RS-232 pass-through Support HDMI loop-out on Transmitter Support audio extraction via To slink of Receiver Support ARC via To slink of Transmitter HDMI Audio Format: PCM DTS Dolby & Amos To slink Audio Format: PCMCIA, Dolby 5.1, DTS 5.
Package Contents Transmitter & Receiver Power adapter DC 5V/2A x2 IR blaster cable IR receiver cable Terminal block x2 (for RS-232) Wall-mount kit x2 User Manual Layout 1.
w ARC out: Connect to speaker or AV receiver 4. Rs-232: Connect to Terminal block 5. Micro USB: For firmware upgrade 6. Reset BUTTON: Press to restart the device 7. JR-45: Connect to Receiver with Catt cable 8. HDMI INPUT: Connect to HDMI source 9. HDMI OUTPUT: Connect to HDMI display 10. POWER JACK: DC 5V/2A Receiver (RX) elm. T=] HEEDED RD BEB BEB BE 41.
B= Audio extract: Connect to speaker or AV receiver ARC Switch: Enable/disable ARC function 5. RS-232: Connect to Terminal block 6. Micro USB: For firmware upgrade 7. Reset BUTTON: Press to restart the device 8. JR-45: Connect to Transmitter with Catt cable 9. HDMI OUTPUT: Connect to HDMI display 10.
Pr DID Auto Balance * The extender will auto-learning connected display's DID from RX, for resolution & audio output channel + If TX loop-out also connected display, the extender will use the smaller display DID of two displays For example: 1. Two displays are 4K@60Hz 2 audio channels & 1080p@60H2 5.1 audio channels, the extender will use 1080p@60HzZ 2 audio channels DID for Two displays. Output resolution will be 1080p@60Hz Audio output will be 2 channels 2. Two displays are 4K@60Hz 7.
Gor RS-232 This product adopts hexadecimal transparent transmission instructions, and use commands to control the transmitter or receiver.
Note: We recommend CAT6/6a with 100% copper wiring and IEEE-568B wiring standard. We recommend HDMI cable do not over Sm Dedicated GIMP Gigabit Ethernet switches are recommended for the best performance and reliability, When connecting to an existing LAN environment, It's recommended to configure a CLAN dedicated to these transmitter and receiver to avoid traffic collision with other networking devices.
Wall mount Q&A Q: Why the status indicator is off? 1. Please check whether all equipment is powered on and the network cable is connected properly. 2. Try to change a network cable to connect. Q: Why is the status indicator has been flashing slowly? 1. Please check whether there Is HDMI signal Input for the TX. 2. Try to connect the signal source directly to the display device, or try to change the signal source and HDMI cable and test again.
Q: Why it keeps showing “Search color on the screen? The transmitter and the receiver are not connected or they are connected but there is no data transmission. Please refer to the above two questions for the solution. Q: Why is the output image unstable? 1. Check whether the length of the network cable connected from TX to RX Is within tetrameters. 2. The length of HDMI cable Is recommended to be <5 meters, 3. Press the "reset" button on TX and RX panels to restart and reconnect.