Installation guide

5
2. Restart your system when prompted by Windows'
installation.
3. At the Windows Setup screen, press F6 to install the
driver.
4. Insert the driver diskette. Press S then press Enter.
5. Select INITIO INIC1620 S-ATA Adapter For
Windows XP/2003 and press Enter.
6. Press Enter to continue and follow on-screen
instructions to complete the installation.
Existing Windows XP/Server 2003 Installation
1. Install the board and boot up Windows.
2. At the Found New Hardware Wizard:
XP (w/SP1 or earlier)/Server 2003: Continue to step #3.
XP (w/SP2 or later)/Server 2003 (w/ SP1 or later): Select
No, not at this time, then click Next.
3. Insert the driver CD, select Install the software
automatically (Recommended), then click Next.
Click Next again to continue.
4. Click Continue Anyway, then click Finish.
Note: Our driver has been thoroughly tested in
Windows for stability.
5. Restart Windows to complete the driver installation.
To Verify Windows 2000/XP/2003 Installation
1. Right click My Computer, click Manage and select
Device Manager.
2. Double click SCSI and RAID Controllers, then
double click Initio inic1620 S-ATA Adapter. A
message This device is working properly is displayed
in the dialog box, the driver has been correctly
installed.