Programming instructions

15
5 LED display
SIVS 610-...
LED signalling IPVS 600-...
The underneath of the IP video server IPVS 600-... has 3 LEDs which display operating statuses and can provide an
indication of possible errors.
LED operating status Function
OFF IPVS 600-... is switched off.
Lights up in green IPVS 600-... is switched on
Flashes green Access to the IPVS 600-...
Lights up in red (briefly) Start process running
Lights up in red (continuous) Error in the device or failed upload
LED L
Lights up in green Network connection exists
LED T
Lights up in orange Active data transmission via the network
LED signalling SIVS 610-...
Switching on
LED green LED red Function
OFF ON After reset, power on: Device boots to operating status.
ON ON The boot area is checked. Software runs in the flash
Fast flashing ON After a software update, the boot area is recreated.
This can take up to around 3 minutes.
Operation
LED green LED red Function
ON OFF Booting is complete. All OK. Normal status
Slow flashing OFF Display, a connection exists
Fast flashing OFF A software update or reconfiguration process is under way
Fault
LED green LED red Function
OFF Slow flashing ERROR, software running only in bootloader.
Program memory defective.
(Device defective, possibly new software update or exchange.)
ON Slow flashing Variobus address error (error remedy possible on site)
ON Fast flashing The 15 V power supply (terminal bv, cv) is overloaded.
(Error remedy possible on site)
OFF OFF If supply voltage is definitely connected, the device is defective.
(Exchange)
Frequencies: Slow appr. 2 Hz, fast appr. 16 Hz