Programming instructions

28
7 DoorCom DCA 740-01 8 DoorCom IP
Factory setting
IPVS 600-...
The DoorCom Analog DCA 740-...
is used as an interface between
DoorCom IP and an analog tel-
ephone connection of a telecommu-
nication system.
It is possible to assign the maximum
number of possible users in a line to
the DCA 740-... . The functionality
depends in the main on the capa-
bility of the telephone system /on
the telephones connected to it.
Assignments and functionality
for calls via the DCA 740-... are
saved in the SII 650-... . This can
be programmed using BPS 650-...
if the connection via DCA 740-... is
selected.
The selection of users and control
and switching functions takes place
by means of DTMF dialling. The
telecommunications system and the
connected telephones must there-
fore possess DTMF dialling capability.
Power supply
The DCA 740-... is supplied directly
from the SIVS 610-... . A separate
supply is consequently not required.
The power to the a/b public net-
work interface is supplied from the
telecommunication system or the
a/b public network connection from
the exchange. It is not possible to
connect an individual public network
telephone directly to the a/b line of
the DCA 740.
With the reset button at the
IPVS600-..., it can be reset to the
as-delivered status. It is essential to
load the Siedle factory configuration
in the IPVS600-... after a reset.
Proceed as follows.
1 Start the Internet Explorer on the
PC and enter the following in the
address line:
http://192.168.0.1
The IP settings in the as-delivered
status of the IPVS610-...
User name: Service
Password: None issued on
delivery
The user interface is opened.
2 Select the Expert mode menu
item
3 Under Expert mode select the
menu point Maintenance.
4 Under Configuration select
"Search“ to find the configuration
file and select.
The file is on the supplied CD.
5 Select the file rtc_image.
6 Start the update with "Upload".